Our "Easy-Wrap" classic bridge design. No tails hanging out - no messing around with the string ends.

Our clients like the clean look and easy and fast string installation.

To string: (1) thread the string through the middle hole on the bottom.

Pull the string back over the tie block and insert it through the upper hole on the bass side. Then, pass it through the loop.

Push the string end into the third hole as far as it will go then pull the string tight.

That's it!

Luthiers: Feel free to use this design. Rick only asks that that you credit him for the design. Please note that you must make a notch with a 3-corner file between the upper two holes to prevent the string from slipping.